Metku.net

MetkuMods
It is currently 13.12.2019 14:31

All times are UTC + 2 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: 29.07.2003 09:06 
Offline
Junior Modder
Junior Modder

Joined: 29.07.2003 08:57
Posts: 1
Hey, i'm trying to make a logo on my mouse but the tape method to hold the glue wont fit over the concavity of the mouse. it always gets bunched up in the middle and i dont want to have to sand it down because i want it to be transparent. HOW can i make the glue match the mouse's concave? any ideas!?!?!?


Top
 Profile  
 
 Post subject:
PostPosted: 22.08.2004 03:52 
Just keep the tape stretched tight while putting it over the hole and it won't bunch.


Top
  
 
 Post subject:
PostPosted: 22.08.2004 05:52 
Offline
Ultra Modder
Ultra Modder

Joined: 09.06.2003 08:30
Posts: 1592
Location: Orlando, FL, USA
get a sheet of plastic, not the flimsy stuff, but the stuff thats kinda hard. put that over the mouse, and use a heat gun to melt the stuff to the mouse. that would have been perfect if you would have done it before ya cut the design into the mouse. if ya got a mouse just like that one, do that to the other mouse. it should work great.

_________________
Image
-=-LSDiodes-=-

Xxcr4shxX: w/e
Crash2108: we?
Xxcr4shxX: what ever
Crash2108: no, tell me what w/e is first


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC + 2 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group