Metku.net

MetkuMods
It is currently 24.04.2014 06:15

All times are UTC + 2 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: a better way
PostPosted: 15.10.2002 14:39 
1. bend a wire to the desired shape (say your initials)
2. heat this (wire) to about 180 - 200 deg.C
3. press it into the plastic top of your mouse (not the easiest thing to do, but if you get it right it will leave an impression).
4. sand and polish the top of your mouse flat again.
5. bake your mouse (just the top of course) and the indentation will reappear
6 presto.... an initial in the top of your mouse

:lol:


Top
  
 
 Post subject:
PostPosted: 15.10.2002 20:26 
Offline
Veteran Modder
Veteran Modder

Joined: 18.08.2002 22:38
Posts: 501
Location: Indiana, USA
that would be no different looking than if youjust uses a dremel...and im not really sure how that would be any easier

_________________
Image
and if you dont like it then to bad


Top
 Profile  
 
 Post subject:
PostPosted: 16.10.2002 13:09 
it's not easier, but it looks better because if all you have to do is sand & polish the whole of the mouse top flat, it is easier to get a really professional clean flat surface, unlike with dremel which can take a long time to make perfectly flat.


Top
  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC + 2 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group