Metku.net

MAIN SPECS:
P4 2.4B @ 3GHZ
Asus P4PE
Creative RX9700 Pro
512M Generic RAM

ok, so it did come with a side window. i only got this one because it was $100 less than the one without. this was because the one without came with a psu which i didnt need. so please keep the flaming to a minimum.
im gonna paint all the outside black, i dont like the current colour.
this isnt completely finished, i dont think it ever will be.


i need to save up some money for some leds


replaced original orange power led. or was it green?


thank you japala




you should see all the wires under the table!!




closer


blue ccfl on


something missing? im gonna window my dvd drive. i have to repaint the psu too

things im gonna do: hack a hole in the front bezel to have 2 ex-trilite led fans with blue and red leds fading in and out with japalas colour fade. i would have done it already but i dont have the tools. stupid lack of money, and i cant get a job until im 14 and 9 months. im sure there were more but i cant remember them at the moment

anyone have any questions/comments/ideas?

sik ive got the same case and you just got me running ito mi dads workshop is the uv drawing hard to do ?

nope, i used fluro paint for the heatsinks and i just coloured the leads of chips and solder with fluro pens

just like to say that I also have the same case . I just got it sunday and im planning on cutting it up over the next week or so. Hopefully I get my tax return soon so I can buy some more parts for it.

BTW its really thick, did you use a jig saw to cut it? Also the USB in it, is it 2.0 or just ole 1.1

_________________

i have a couple of thing to say about those usb ports
1# theyre not secured in properly and wobbbble around
2# they r usb 2.0 wicch is good
3#i replaced them with switches for my cathodes (its much more useful)

yes, i used a jigsaw with a saw meant for cutting metal. the metal is 1mm thick i think. the jigsaw cut through it pretty eaisily.