Alter the input voltage
Page 1 of 1

Author:  submission [ 03.08.2015 18:18 ]
Post subject:  Alter the input voltage

Hi everyone, long time to posting here.

So about the Opto, is there a way to alter the input voltage of the HD LED without harming it? The reason is because the Opto is always active even without an HD pulse, the LEDs emit a very low output. I assume it can be solved by adding resistance to the HD LED signal, but is that safe?

- Dan

Page 1 of 1 All times are UTC + 2 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group