MetkuMods

Project: Eutanasia

Small Aluminum Case with Water Cooling
Author: Toni Siik
Published: 14.01.2008
In English In English
Suomeksi Suomeksi

Cooling the Beast

As I've mentioned earlier, I chose to use watercooling in this project. So here are some pictures of the cooling hardware that I used.

 

Sides
A HWLabs Stealth GT 240 radiator, EK Wave AM2 Acetal cpu-block and a pair of Aerocool fans.

 

Sides
Here's the pump I chose for the task, a Laing DDC-1Plus pump with a replacement top from Petra's Tech shop.

 

Sides
 

Here you can see how much room I actually had over the CPU area. The power supply actually ended up hitting the corner-fittings on the cpu-block.

 

Sides
 

Routing out the watercooling system really could've been easier. The space I was dealing with really didn't allow me to build the most efficient cooling-loop.

Despite the problems that my tight design caused, I managed to finish the coolingloop just in time. This picture was taken 2 nights before Assembly 07 started, so I really didn't have that much time to play with.




Pages:  1 2 3 4 5 6 7 8 9 


 
  Content in english!
  Sisältö suomeksi!

 Google

 .:Notice!
En ota mitään vastuuta tuhoutuneesta tai hajonneesta laitteistosta tai sen osasta.

Disclaimer! I will not take any responsibility for any destroyed or damaged hardware.




Add to Technorati Favorites
add
add
add
add
add

 .:Back to top Bandwidth by Mpoli

Copyright © Metku.net, All Rights Reserved.
All content and graphics in MetkuMods are sole property of Jani Pönkkö and may not be reproduced or copied in any manner without written permission from him.
All brand names, trademarks and copyrights are the property of their respective owners.Privacy Policy