MetkuMods

Project: GhettoBlaster

Portable Amplifier and Speaker Box
Author: Antti Hakala
Published: 12.12.2007
In English In English
Suomeksi Suomeksi

Metal work

 

Fabricating the needed metal pieces that will go to the GhettoBlaster
 

Case needed some aluminum parts. These will make it look better and add functionality in form of access hatches. Jigsawing, filing and sanding. Yeah lots of all those phases. After some physical pain the metal work phase is happily over.

 

Fabricating the needed metal pieces that will go to the GhettoBlaster
 

Don't use the drill like shown on the left, you'll lose your fingers! Use a clamp. That specific hole was a nightmare, 20mm in diameter.




Pages:  1 2 3 4 5 6 


 
  Content in english!
  Sisältö suomeksi!

 Google

 .:Notice!
En ota mitään vastuuta tuhoutuneesta tai hajonneesta laitteistosta tai sen osasta.

Disclaimer! I will not take any responsibility for any destroyed or damaged hardware.




Add to Technorati Favorites
add
add
add
add
add

 .:Back to top Bandwidth by Mpoli

Copyright © Metku.net, All Rights Reserved.
All content and graphics in MetkuMods are sole property of Jani Pönkkö and may not be reproduced or copied in any manner without written permission from him.
All brand names, trademarks and copyrights are the property of their respective owners.Privacy Policy