Project: HybRed

Author: Ville 'Willek' Kyrö
Published: 12.09.2006
How difficult: 1 Dremel - Easy ; 5 Dremels - Difficult
Time to finish: 150 hours
Cost: 100-150 euros
In English In English
Suomeksi Suomeksi

GPU Cooler

I have already used this method of cooling the gpu in Aluminum Spire and though the copperplate with aluminum fins looks horrid, it works well, actually even better than the noisy whining stock cooler.

Copper, copper, more copper.

Here is the copper piece with the graphics card (GF 6600gt AGP) for size comparison. I had to cut a notch on the side for a capacitor to make it fit.


Here the same copperpiece is cooling the PCI-e GF 6800gt. I only needed to drill a couple of holes to make it fit on the second geForce. There is an aluminum holder locking the copper cooler in place. Without this, the weight of the cooler would surely break the graphics card.

Pages:  1 2 3 4 5 6 7 8 9 10 

  Content in english!
  Sisältö suomeksi!


En ota mitään vastuuta tuhoutuneesta tai hajonneesta laitteistosta tai sen osasta.

Disclaimer! I will not take any responsibility for any destroyed or damaged hardware.

 .:Back to top Bandwidth by Mpoli

Copyright ©, All Rights Reserved.
All content and graphics in MetkuMods are sole property of Jani Pönkkö and may not be reproduced or copied in any manner without written permission from him.
All brand names, trademarks and copyrights are the property of their respective owners.Privacy Policy