MetkuMods

Project: HybRed

Author: Ville 'Willek' Kyrö
Published: 12.09.2006
How difficult: 1 Dremel - Easy ; 5 Dremels - Difficult
Time to finish: 150 hours
Cost: 100-150 euros
In English In English
Suomeksi Suomeksi

Assembling the stand



The rings were cut from 5 mm plexy, and as the long nuts between the aluminium plates were conviniently 15 mm thick, I only needed to cut strips from 5 mm plexy and make a sandwich. I purposefully left out the paint from the insides of the stand to make the light reflect better. If you look closely, you might see where the leds are going to be placed.



Closeup


Testing with batteries

Let there be light!


"Tilt control"

The bolt is attached to the backplate and the wing nut controls how far the displaycomputer is tilted. I planned to use a motor for the tilt, but the motor I had, had way too slow gearing and it sounded weak. The wing nut does its job, and I donĀ“t have to adjust the tilt so often anyway.




Pages:  1 2 3 4 5 6 7 8 9 10 


 
  Content in english!
  Sisältö suomeksi!

 Google

 .:Notice!
En ota mitään vastuuta tuhoutuneesta tai hajonneesta laitteistosta tai sen osasta.

Disclaimer! I will not take any responsibility for any destroyed or damaged hardware.




Add to Technorati Favorites
add
add
add
add
add

 .:Back to top Bandwidth by Mpoli

Copyright © Metku.net, All Rights Reserved.
All content and graphics in MetkuMods are sole property of Jani Pönkkö and may not be reproduced or copied in any manner without written permission from him.
All brand names, trademarks and copyrights are the property of their respective owners.Privacy Policy