MetkuMods

LOGiWOOD

5.1 Speaker Set Mod with Natural Materials.
Author: Antti Hakala
Published: 03.04.2007
In English In English
Suomeksi Suomeksi

Volume controller



 

PCB of the volume controller was too complicated for me to take apart, so I was 'forced' to use it as it was. I started the new case with 4 mm clear acryl cut with jigsaw. This was followed by some precise measurements, hole drilling and filing to make it look better.



 

After watersanding the edges, I painted the acryl from the backside. Notice how bad the painted surface seems on the center photo, and still it turns out great in the last photo. I used the original volume knob and LCD frame because I think they look good. Would be waste of time trying to DIY better results on this particular project.




Pages:  1 2 3 4 5 6 7 8 9 10 


 
  Content in english!
  Sisältö suomeksi!

 Google

 .:Notice!
En ota mitään vastuuta tuhoutuneesta tai hajonneesta laitteistosta tai sen osasta.

Disclaimer! I will not take any responsibility for any destroyed or damaged hardware.




Add to Technorati Favorites
add
add
add
add
add

 .:Back to top Bandwidth by Mpoli

Copyright © Metku.net, All Rights Reserved.
All content and graphics in MetkuMods are sole property of Jani Pönkkö and may not be reproduced or copied in any manner without written permission from him.
All brand names, trademarks and copyrights are the property of their respective owners.Privacy Policy