MetkuMods

Animating Multilayered Engravings

Get some movement and color to your engravings.
Author: Jani 'Japala' Pönkkö
Published: 20.02.2008
In English In English
Suomeksi Suomeksi

The Dragon

 

The Dragon
 

Now this is looking much better! I made this engraving while I was testing out the Dremel's 290-05 Engraver tool. Please, check out my other pieces too. Btw. AllTheMods is our new Modding Gallery that offer space for your own modding images. It also allows one to write modding project logs and articles too. Joining is free so test it out.

The Flames

 

The Flames
 

Dragons tend to breath fire so it was only natural to Google for some reference flames. Now that the flames will be sitting ontop of each others the aligment and order of the layers becomes much more important. For this design the Dragon will be on the topmost layer and the flames will go from smaller to larger below that.

 

Four layers
 

Four layers, 3 mm each so the end result will be a whopping 12 mm. Anything beyond this and I'll be using a 7" TFT panel as a replacement.

And as always, ENGRAVING GOES TO THE BACK SIDE AND AS A MIRROR IMAGE!

 

Dragon engraved
 

Everything engraved and all seem to line up properly. Now comes the taping, glueing and hooking up the leds.




Pages:  1 2 3 4 5 6 


 
  Content in english!
  Sisältö suomeksi!

 Google

 .:Notice!
En ota mitään vastuuta tuhoutuneesta tai hajonneesta laitteistosta tai sen osasta.

Disclaimer! I will not take any responsibility for any destroyed or damaged hardware.




Add to Technorati Favorites
add
add
add
add
add

 .:Back to top Bandwidth by Mpoli

Copyright © Metku.net, All Rights Reserved.
All content and graphics in MetkuMods are sole property of Jani Pönkkö and may not be reproduced or copied in any manner without written permission from him.
All brand names, trademarks and copyrights are the property of their respective owners.Privacy Policy