Wooden Spire

Case made out of natural materials.
Author: Ville 'Willek' Kyrö
Published: 24.01.2007
In English In English
Suomeksi Suomeksi

Putting it together

I drilled holes in the middle panel to make it lighter and to ensure free airflow between sections.

Since the construction is so simple, forces at play are so weak that I could use only glue to hold the pieces together.

Bending the side panels

The sidepanels were made out of plywood. I used three 4 mm thick panels. I cut arcs out of scrapwood, and used them with clamps and glue to bend the plywood to the shape I needed.

After the glue dried the side panels held their shape as planned.

Almost ready for surface treatment. Only minor tweaks are needed before I could put some color to it.

Pages:  1 2 3 4 5 

  Content in english!
  Sisältö suomeksi!


En ota mitään vastuuta tuhoutuneesta tai hajonneesta laitteistosta tai sen osasta.

Disclaimer! I will not take any responsibility for any destroyed or damaged hardware.

 .:Back to top Bandwidth by Mpoli

Copyright ©, All Rights Reserved.
All content and graphics in MetkuMods are sole property of Jani Pönkkö and may not be reproduced or copied in any manner without written permission from him.
All brand names, trademarks and copyrights are the property of their respective owners.Privacy Policy