|
|
In English
SuomeksiInstallation continued
Here we have a picture of the 3.5" drive cage with a drive installed. Installing the drive into the cage is completely straightforward and the only possible mistake that you might make is to install the drive so the sata- and power-plugs face the wrong way.
After I had the HDD installed in the cage, I tried to refit the cage in its place, but I had some trouble getting the tabs to slide in properly so the HDD wouldn't come tumbling down onto the motherboard. I wish SilverStone had done something to make getting the cage back in, easier. Like a proper rail-system or something.
On the second shot one can also see how much space the HDD takes away from the case. Fortunately it doesn't come that much lower than the powersupply so you shouldn't encounter any problems with the clearances, at least not vertically.
Now we've finally gotten the case assembled far enough to start installing the graphics card. My card of choice today is the Palit HD4850 Sonic, which is a tad shorter than the reference HD4850, so it should go in nicely.
To begin installing the graphics card, you'll have to unscrew the three screws which hold the corner-piece on the top of the expansions slots.
 | Pages: 1 2 3 4 5 6 7 8 |  |
Content in english!
Sisältö suomeksi!
