MetkuMods

NZXT Switch 810

Stylish and well ventilated case!

Bookmark and Share  
Author: Lauri 'lauri_lr' Rahtu
Published: 17.01.2012
Manufacturer: NZXT
Product Group: Enclosures
In English In English
Suomeksi Suomeksi
 

HDD Cage

 

NZXT Switch 810 - Stylish and well ventilated case!
 

The HDD cage is removed by first removing four thumb screws from the left side of the case and two screws from the right side of the case. The screws at the right side of the case aren’t necessary so you don’t have to care about them once you’ve removed them.

After all the screws are removed just grab the handles of the HDD cage and pull.

 

PSU

 

NZXT Switch 810 - Stylish and well ventilated case!
 

There are six rubber rests for power supply. Once again, the rubber is supposed to prevent any resonance. Power supply can be installed in both ways because there are air ventilation holes at the bottom of the case. Personally I’d install the power supply by facing the fan down. There’s also a dust filter for the power supply’s air intake.

 

Led lighting

 

NZXT Switch 810 - Stylish and well ventilated case!
 

At the rear panel there are two LEDs (other above I/O panel and another above extension card slots) that you can light up when you’re trying to plug for example an USB device to your computer and it’s dark in the room. The switch for these LEDs is in the front panel next to the reset switch. This switch can be seen in the picture that shows case’s external connectors.




Pages:  1 2 3 4 5 6 7 


 
  Content in english!
  Sisältö suomeksi!

 Google




Add to Technorati Favorites
add
add
add
add
add

 .:Back to top Bandwidth by Mpoli

Copyright © Metku.net, All Rights Reserved.
All content and graphics in MetkuMods are sole property of Jani Pönkkö and may not be reproduced or copied in any manner without written permission from him.
All brand names, trademarks and copyrights are the property of their respective owners.Privacy Policy